Tapo C200 Clamp for IKEA Lack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a c-clamp camera mount inspired by smaller clamps for thinner tables and the C100 cam, ready for Lack tables
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 137
- Wydruki
- 1
- Wyświetlenia
- 1050
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
I made this model because I couldn't find andy clamp style mounts for my C200 IP Cam, in the hope that it wouldn't wobble as much as a top/wall mount.
The only things I could find were wallmounts or smaller clamps for the c100, so I tried to do my best and make one myself.
This is my first ever 3d job and I hope that it's not that bad.
The Clamp is usable for a thickness up to 6cm and increase the hight by about 10cm.
Printer settings:
Prusament PETG 10% adaptive cubic but with more infill around the holes (also 3d honeycomb instead) and the handle is fully 3d honeycomb with 25% infill (same for screw of the mounting part), had my first try without additional support for the screws, that broke while screwing it in.
Printable without supports, it should be screwable, but with tight tolerances.
Inspired by TP-Link Tapo Cam Holder (C100) from oe7mbt but made from ground up and “beefed it up”.