Clamping Knobs for T-Track
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Recently, I made a drill press table with fence, router table with fence and bench clamps and needed some knobs to…
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 115
- Wydruki
- 1
- Wyświetlenia
- 887
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Recently, I made a drill press table with fence, router table with fence and bench clamps and needed some knobs to secure the fences and clamps using installed T-track.
So, I whipped up these two versions using Fusion 360 with the following design parameters:
- Had to work with 1/4" 75mm long bolts with square nuts that I already had laying around.
- Had to have a diameter no wider than than the drill press fence which was two 3/4" plywood boards sandwiched together at least for the smaller version (3/4" = 19mm).
I hope you find these useful.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
50%
Filament: eSun PLA+ 1.75mm Black
Notes:
I printed mine without supports which resulted in some cleanup afterwards but nothing that caused any issues.
Using Fusion 360
Category: Tools