Quefrency 65% with macro - case with 10 degree tent
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a modified version of the rev2 case found here: https://github.com/keebio/quefrency-case. Tested with PCB rev3…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 544
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is a modified version of the rev2 case found here: https://github.com/keebio/quefrency-case. Tested with PCB rev3 (USB-C).
The modification tents the keyboard halves by 10 degrees, and adds a little palm rest tray and 2 front legs for each half.
You will need 16x M2 20mm screws and washers. The screws go in from the bottom and screw into the top pieces (just like the original case, directly into the plastic).
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20
Filament: Hatchbox PLA Wood Post-Printing =============
The final print may or may not wobble depending on how well your Z axis is calibrated. Mine wobbled quite a bit. I stabilized it by adding silicone feet, and then filing down the silicone feet that caused the wobble.
The palm rest pads are from here:https://www.amazon.com/gp/product/B00519TMAY/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1
Most of the keycaps are these: https://www.amazon.com/gp/product/B08YR8KDSL/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&psc=1
The custom key caps (capslock and most of the macro pad) are from WASD.
Category: DIY