Servo Trigger - GoPro Hero 4 Session
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted to experiment with those cool time-lapses you see of prints, where a picture is taken after each layer.…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 417
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
I wanted to experiment with those cool time-lapses you see of prints, where a picture is taken after each layer. Because I only a Go Pro Hero 4 Session as usable camera, and I couldn't find any way of triggering it over a wire from my printer, I designed a mount that uses a SG90 servo to trigger the camera.
I'm still figuring out how to connect my servo and configure it in the Marlin firmware to take a picture after a M280 command in the G Code.
Any help is welcome!
Edit 10/02/2019:
I added a Go Pro mount to the frame. There is a version with it on the front and one with it in the back. The one with the mount in the back is easier to print, the other could need some supports.
I also found out how to trigger the camera with Marlin. Write a comment if you need some help to get you started, i'll be happy to help.
Print Settings
Printer:
Anet A8
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0,2mm
Infill:
30%
Filament:
Fil-a-Gehr ABS
White
Notes:
Use a 0.4mm nozzle or smaller.
Category: Camera