Manta Mk2 REMIX for drag chains
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Added mount for a drag chain, deleted some geometry to optimize for chain, and add ADXL mount.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 53
- Wydruki
- 3
- Wyświetlenia
- 598
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a Remix of Boothy's Manta MK2 duct system for the Ender 3.
I updated some parts to fit better with my setup, as I have a drag chain on my hotend, and wanted to add a connector for the chain.
Summary of changes:
- Rear_Mount_Plate - Replaced heatset insert holes with screw holes, added indexing cutout for drag chain mount, changed sacrificial layers on some of the screw holes.
- Stock_Clamp__Fan_Shroud - Optimized for printing upside down - eliminated sacrificial layers and support feet.
- Universal_Duct_Base - Lessened an overhang near cable cutout on right
- Support_Arm_Bowden_RH - Deleted wire support.
- Drag_Chain_Mount - new
- BLTouch Center Mount with ADXL - added mount for ADXL345 sensor. BLTouch offset values are unchanged: X:0 Y:-37.7
Only parts with changes (individual .STLs and single .STEP) are uploaded, see Boothy's original for other part.
© CC-BY-SA