Kyria Pimoroni Trackball Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount for the pimoroni trackball to go on a kyria keyboard. The 3 similar designs (not the "original") would…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 660
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a mount for the pimoroni trackball to go on a kyria keyboard. The 3 similar designs (not the "original") would probably fit in any case, but the original is pretty specific to the case found here, which can also be seen in the pictures. I also took the kyria logo for one of the designs from that case.
This will require a few M2 screws to attach the trackball to the mount and the mount to the keyboard. with one of the 3 similar newer designs, mine used two M2x4mm screws for the trackball->mount, and one M2x8mm for the mount->keyboard.
Print Settings
Printer:
Sunlu S8
Rafts:
No
Supports:
Doesn't Matter
Resolution:
2
Infill:
20
Filament:
Sunlu PETG
White
Notes:
I printed it with supports, but it should work either way. It's a fairly short bridge to get across on the bottom of the wire shield.
This took me about 15 minutes to print at 50 mm/s.Category: Electronics