1 / 6
Prusa Enclosure MMU2S / MMU3 - filament guide — zdjęcie 1
1 / 6

Prusa Enclosure MMU2S / MMU3 - filament guide

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I bought MMU2S upgrade and then build Lack enclosure. As many of us I wanted to keep it and use printer as single one!

Ocena
5 / 5
Polubienia
13
Pobrania
55
Wydruki
1
Wyświetlenia
1071
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I bought Prusa i3 MK3S+ and MMU2S upgrade. Then I built lack enclosure for this setup. After few months of using, I decided that sometimes I want to use 3D printer as basic MK3S+ so i designed this filament guide to easily use enclosure as built before.

I made few evolutions of my model. So, I decided to upload all of them. Best for use is Filament guide LackMMU2S_short_5mm. This one is perfectly long to not bend filament too much and to be as smooth going into enclosure to not damage print quality.

Printed from PETG at 0.15mm layer height with 20% of infill. No support and brim needed. Holes are bridged by two layers, but it is very easy to go through with screw.

Hole is 5mm thick, therefore you could go through it with PTFE tube for use with filament dryer.

You would need 2x M3 10-20mm screw and 2x M3 nut. One advice - try to look for them in spare parts you get with your MK3S+. Then you need to make hole for screws to go through and hole for filament.

Tagi