Summer Waves Pump delete spacer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you cut the bottom out of a 5gal bucket to plug the opening left by the old pump, you'll need this to fill the gap.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 390
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
We upgraded to a sand filter and had to remove the original pump from the skimmer; debris was creating clogs. Being the typical male, I decided to cut the bottom out of a 5gal bucket instead of paying (and waiting for) an injection molded part made for the task. The bucket was too thin so the collar couldn't seal it against the housing; 3D printing to the rescue. Here's a spacer that takes up the rest of the clearance plus a bit extra for good measure. It should be 6.4" (162.5mm) in diameter when imported into your slicer.