Summer Waves Pump delete spacer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
If you cut the bottom out of a 5gal bucket to plug the opening left by the old pump, you'll need this to fill the gap.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 30
- Makes
- 0
- Views
- 390
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
We upgraded to a sand filter and had to remove the original pump from the skimmer; debris was creating clogs. Being the typical male, I decided to cut the bottom out of a 5gal bucket instead of paying (and waiting for) an injection molded part made for the task. The bucket was too thin so the collar couldn't seal it against the housing; 3D printing to the rescue. Here's a spacer that takes up the rest of the clearance plus a bit extra for good measure. It should be 6.4" (162.5mm) in diameter when imported into your slicer.