CR10/CR10S Hot-End/X-Motor, Heat Bed Cable Management
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cable management system for the CR10/CR10S heat bed and hot-end. You can use them on their own (ie just the bed, etc).
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 1385
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Description
I upgraded my heatbed to use a silicon heater pad, and wanted to be able to easily attach/detach the heatbed and add a thermal fuse. I've used Wego221 lever nuts to make life easier.
This mod will also work for folks with the standard Creality bed- just clip the wires with enough slack to run though the lever-nuts. Note you do not need a thermal fuse for this setup.
Along with the bed mod, I'm also including my x-axis/extruder cable management mount for the CR10/CR10S, and a dual drag-chain mount point for the back right of the printer. Note that this mod does not work for bowden systems as it uses the old bracket on the x-gantry where the e-motor was mounted to security attach the drag-chain.
Bill of Materials:
Heated Bed:
Note the slightly different bill of materials for the silicon heater pad vs Creality stock.
with Silicon Heater Pad:
4x M3 brass heat-set insert
1x 230v 125C thermal fuse
5x Wego221 lever-nuts
3x M3x5mm bolts
VHB Tape
Zip Ties
with Stock Creality Heated Bed:
3x M3 brass heat-set insert
4x Wego221 lever-nuts
3x M3x5mm bolts
VHB Tape
Zip Ties
Extruder/X-Axis:
6x M3 brass heat-set inserts
6x M3x5mm bolts
Zip Ties
Dual Drag-Chain 2020 Mount:
6x M3 brass heat-set inserts
6x M3x5mm bolts
2x M5x10mm bolts
2x M5 T-nuts
Notes on the Drag-Chains
The drag-chain attachment point uses a generic 3 screw setup, and can accommodate drag chains up to 20mm wide channels (28mm exterior width).