slightly less springy Lowrider2 Dewalt DW611 pen holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
changed to screws to hold pen and friction mount in DW611 router plate.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 276
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This is a remix of Tailslide's DW611 Pen Holder. I got rid of the zipties and use screws. I also tried to take out some springiness (I printed in PLA+ and it is still very springy).
The two smaller pieces are superglued to the underside (sand the mating surfaces first) at the slit in the ring and a m3x20 screw is used to slightly spread the ring apart for a friction fit in the 611 plate.
If you have the vacduct in place (I attached mine permanently so I removed the upper lip in Tailslides since I could not clip onto the top of the 611 plate because of the vacduct) , then the three m3 screws at the top should be slightly shorter than m3x8 to fit through the vacduct hole properly.
I used panhead M4x8 screws and hex head m3 screws (three M3x8 and one M3x20 (although this one could be shorter). They all used the same size Allen wrench.
I tried to design out some flex but it is still quite flexible. It printed in about an hour and a half at 0.28 layer height. The slit may be slightly fused since the gap is only 1mm but should separate very easily.
Enjoy!