Technoblade Memorial Repaired for FDM
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fixed DJScope's version to make it printable on my FDM. Prints at 3 1/2 inches tall or higher.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 133
- Wydruki
- 0
- Wyświetlenia
- 903
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Fixed DJScope's version to make it printable on my FDM. Prints at 3 1/2 inches tall or higher. Supports must be used! My daughter is a huge fan of Technoblade and I fixed this so I could print it for her. I make my fixed verson available for the rest of his fans here.
My Fixes (verified at 3 ½ inches or 8.9 cm tall):
-Minimum thicknesses of parts set to 1mm.
-Scaled to 3 ½ inches tall or 8.9 cm
-Repaired mesh errors.
-Reduced detail to make printable.
My tested print settings (took 5hrs):
-.2mm to .32mm variable layer height (the base at .32).
-Painted on supports for 35-degree parts.
-Printed at 3 ½ inches tall.
-10% support cubic infill.
-Perimeters set to 2.
-Printed with Overture PLA.
I recommend if you are not conformable using painted supports or variable layer heights, use .2mm and supports everywhere. I also recommend you set the support overhang threshold to 45-degrees because the back angle of the cape can be tricky if your adhesion is not great.
Model made possible by art originally from @raxifire on Sketchfab: https://sketchfab.com/3d-models/technoblade-dreamsmp-fanart-35c6215307f8456abd596e29e2ef138c.