Technoblade Memorial Repaired for FDM
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fixed DJScope's version to make it printable on my FDM. Prints at 3 1/2 inches tall or higher.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 133
- Makes
- 0
- Views
- 903
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Action Figures & Statues
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Fixed DJScope's version to make it printable on my FDM. Prints at 3 1/2 inches tall or higher. Supports must be used! My daughter is a huge fan of Technoblade and I fixed this so I could print it for her. I make my fixed verson available for the rest of his fans here.
My Fixes (verified at 3 ½ inches or 8.9 cm tall):
-Minimum thicknesses of parts set to 1mm.
-Scaled to 3 ½ inches tall or 8.9 cm
-Repaired mesh errors.
-Reduced detail to make printable.
My tested print settings (took 5hrs):
-.2mm to .32mm variable layer height (the base at .32).
-Painted on supports for 35-degree parts.
-Printed at 3 ½ inches tall.
-10% support cubic infill.
-Perimeters set to 2.
-Printed with Overture PLA.
I recommend if you are not conformable using painted supports or variable layer heights, use .2mm and supports everywhere. I also recommend you set the support overhang threshold to 45-degrees because the back angle of the cape can be tricky if your adhesion is not great.
Model made possible by art originally from @raxifire on Sketchfab: https://sketchfab.com/3d-models/technoblade-dreamsmp-fanart-35c6215307f8456abd596e29e2ef138c.