Adimlab 310x310x410 Gantry printer mods
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
X_Belt - allows use of stock belt & mounting screws but will allow easy tension adjustment of the X axis belt -…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 784
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
X_Belt - allows use of stock belt & mounting screws but will allow easy tension adjustment of the X axis belt - printed with 3 perimeters, .2 layer PLA
(Updated 01-09-2019) - better belt locking, more adjustment
PM-C07_Z_bracket - has longer slots for mounting the Z endstop. This allows you to fine tune the position of the nozzle homing position closer to the build surface, putting the bed springs under more tension for more rigidity. Should also have enough adjustment to be able to remove the glass and apply a Buildtak surface directly to the aluminum for gaining another 4mm build height. 3 perimeters, 60% infill, .2 layer, PLA
FIlament_det_bracket - clip on design that allows the filament detector to ride on the X carriage. You will need to extend the wiring for the detector & route it through the cable chain. Make sure you add enough wire to allow travel to full build height.
Y_belt_holder - added a screw hole to the stock holder to allow addition of a 5mm screw to keep belt clamped tight. Print in PETG or PLA. Don't tighten the clamp screw too tight if you use PLA. 3 perimeters & 50% infill
(updated 03-18-2019)
Bondtech_mount - mounts to stock X carriage. Designed for Bondtech BMG standard extruder/E3D v6 hotend. Uses E3D polycarbonate heatsink duct with supplied fan (make sure you order 24v heater & fan)
Bondtech_fan_duct - uses stock ADIMLab hotend fan as part cooling fan. Plug into PWM fan socket. Plug the existing LED into the LED socket. You will need some additional 3mm screws to mount the fan & fan duct.
(updated 03-30-2019)
Stiffner_parts - uses 3/8" wooden dowels to stiffen the Z gantry. You will need some 5mm bolts & slot nuts to attach the printed parts. Cut the dowels to length & sand for a snug press fit. Use a bit of CA glue if you feel it necessary. Will not interfere with full height print volume.
Print instructions
Category: 3D Printer Parts Print Settings
Printer Brand: Prusa
Printer: i3 MK2.5
Rafts: Doesn't Matter
Resolution: .2
Infill: 60%
Filament: Solutech 3D PLA or PETG any