Remix of Leifheit Click System Holder by DirkHoefle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Leifheit Click System Holder by DirkHoefle optimized for using PLA as print material.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 115
- Wydruki
- 1
- Wyświetlenia
- 815
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to store some of my Leifheit cleaning equipment on a wall or under a cupboard. So i searched for printable mounts. I found the mount provided by DirkHoefle and printed it. Unfortunately it broke for me on second use because PLA is very brittle and the spring was design very short. So I came up with this remix to improve the design for my use.
In the end I came up with a design for a support free spring design which works with PLA. It took me a lot of revisions to optimize it an allow a smooth insertions in the equipment. This remix is usable in two ways. You can use the parts to fix the original parts or directly print the remixed part.
I think in the future I will make completely new designs for the Leifheit system to make it more easy to expand for every one.
I would be happy to see some of your makes posted :)
Modifications on the remix:
- Separated tongue from tube
- Reduced the tube 3mm in height (it got stuck on my equipment)
- Complete redesign of the tongue
- Designed the tongue as a separated insert from the top (mainly to be able to fix my broken part)
- Added a spline based spring mechanism which works with PLA (for my material)
- Made the tongue a little bit smaller and rounded it to fit in the equipment better
- Moved tongue 1,5mm out of the cylinder to have it seated better in the equipment hole
- Added an angled slide to allow smooth insert in to the equipment
Info before printing:
- I recommend to print the “leifheit_tube_remix” first end measure the size of the top hole and compare it to the measurements I have provided (see image).
- In case your tube hole size varies I suggest to scale the model a little bit in the slicer.
- Alternatively you can thicken the diameter of the “fix_plug” with tape or secure it with some super glue. But it is designed as a press fit.
Print instructions:
- Minimal support needed (see image)
- Part is mostly optimized for 0,3mm layers
- Use 5+ walls to ensure the spring is solid material
Assembly:
- Solution 1: To fix the original part:
- Saw of 3mm of the original tube (gives a better fit for me)
- Chamfer the edges
- Press in the “fix_plug”
- Done.
- Solution 2: To fix the original part:
- Press in the “fix_plug”
- Press in the “distance_piece_3mm”
- Done.
- Solution 3: Print the remix:
- Print the “leifheit_tube_remix”
- Press in the “fix_plug”
- Done.
Optimization:
- I suggest to sand/file of the edges from the tongue (see images).
- This will remove the ripples from the layers and allow a smooth insertion in the equipment parts.
Source files in the Alibre Atom format is available but the website does not allow the upload. If you need it send me a message.