Milwaukee M18 tool holder (circular saw)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Should have the required clearance for the circular saw.
- Ocena
- 0 / 5
- Polubienia
- 57
- Pobrania
- 410
- Wydruki
- 2
- Wyświetlenia
- 2159
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I couldn't find one I liked so I decided to design my own.
I print these in PLA+, 0.28 layer height, 6 walls and 45% infill with a 0.6mm nozzle. Supports everywhere and they break off pretty easy and clean with the right settings. Maybe a bit overkill but I have printed lots of these and never had one fail.
This should have enough clearance to fit the circ saw. It is a bit of a waste of filament in my opinion as the same result could be achieved by just mounting a block under the regular holder but in case you want them to all have the same look, here it is.
I put support blockers in the cavity to save a bit of filament. The finish was a bit ugly where it was bridging, but its hidden when mounted anyways.