Fein Turbovac to 2-1/4" Shopvac adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Connect a Shopvac hose to the Fein Turbovac.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 604
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Simple adapter with a complex retention clip to connect a 2 ¼" shopvac hose to the Fein turbovac directly.
The shopvac hose hose already connects just fine to the turbovac, but I wanted the locking/bayonet connection.
Print the adapter at 0.3mm layer height, with supports for the retaining hole (only). Break away the 3 triangles at the Fein vacuum end after printing, and cut the single layer support inside. The breakaway supports are small, and you may need to toggle "detect thin walls" depending on your print settings.
Print the retention clip at 0.2mm, with flat end down.
I don't have a replacement for the hose gasket, but one is available for printing with ninjaflex here: https://www.printables.com/prints/83984-fein-shop-vac-cyclone-dust-extractor
If anybody knows where to buy this gasket directly, let me know!