Tiara with parametric openscad Included
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use the premade STL or create custom size version with the openscad parametrics.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 76
- Wydruki
- 0
- Wyświetlenia
- 395
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Costume Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Use the pre-made stl files and print directly or use the parametric openscad file to create your custom sized Tiara.
The openscad only has a few parameters, as follows:
Diameter: as described this is the diameter of the tiara.
fn: This is how smooth you want the curves to be . I put this in originally for test purposes , I would advise to not go too far above 50, as this will increase the render time.
model: Choices are as follows:
Tiara: This will display the tiara model with the slots and holes for the gems to fit into.
Gems: This will display the four gems to fit to the tiara.
Center_gem: This will display the longer gem that fits to the front center of the tiara.
Complete: Will display the tiara complete with the gems included, if you wanted to just print it all in one colour.
Print settings:
The tiara prints fine with no supports , no adhesion, I printed this one at 0.2mm with 20% infill.
The gems I printed with no supports and no adhesion at 0.2mm with 20% infill.
Centre Gem is the same but I used brim to be on the safer side.
FYI when rendering the tiara it will take a little while , it may seem it has froze or crashed , just grab a coffee and wait.