Tiara with parametric openscad Included
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Use the premade STL or create custom size version with the openscad parametrics.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 76
- Makes
- 0
- Views
- 395
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Costume Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Use the pre-made stl files and print directly or use the parametric openscad file to create your custom sized Tiara.
The openscad only has a few parameters, as follows:
Diameter: as described this is the diameter of the tiara.
fn: This is how smooth you want the curves to be . I put this in originally for test purposes , I would advise to not go too far above 50, as this will increase the render time.
model: Choices are as follows:
Tiara: This will display the tiara model with the slots and holes for the gems to fit into.
Gems: This will display the four gems to fit to the tiara.
Center_gem: This will display the longer gem that fits to the front center of the tiara.
Complete: Will display the tiara complete with the gems included, if you wanted to just print it all in one colour.
Print settings:
The tiara prints fine with no supports , no adhesion, I printed this one at 0.2mm with 20% infill.
The gems I printed with no supports and no adhesion at 0.2mm with 20% infill.
Centre Gem is the same but I used brim to be on the safer side.
FYI when rendering the tiara it will take a little while , it may seem it has froze or crashed , just grab a coffee and wait.