1 / 7
Tape Cutter with Hacksaw blade
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Packing / masking / duct tape (2") cutter sleeve. Works better than standard PLA only versions. Req hacksaw blade
- Ocena
- 4,5 / 5
- Polubienia
- 60
- Pobrania
- 178
- Wydruki
- 2
- Wyświetlenia
- 1749
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 2) (Komentarze: 3)Remiksy (0)Kolekcje (84)Powiązane
Tape cutting sleeve for 50mm (2") wide tape rolls.
Read reviews of PLA only versions that didn't do a good job a cutting the tape, so designed one with a serrated blade.
Material : PLA
Layer height : 0.20mm
Supports : No *
*Printed mine with supports for the small round holes, then had trouble cleaning them out.
Requirements
- Old or new hacksaw blade.
- Tin snips
- Drill with ~5mm bit for steel
- Sml zip tie.
Steps.
- Print model in PLA.
- Trim a new or old (I used old) serrated hacksaw blade to 50mm using tinsnips.
Nb. a cutter blade could be used but the interest of safety I used a serrated blade. - Insert blade into a print so he blade buts up against the end & side of the channel.
- Use a permanent marker to mark the hole positions on the blade.
- Remove the blade and score the drill points with a punch.
- With a high speed steel bit (~5mm) drill 2 holes where in the marked positions.
(I used an old piece of timber and secured the blade with nails) - Re-insert the blade into the cutter sleeve and check the hole alignment.
- Secure with a sml zip tie, ensuring the buckle is on the outside.
Enjoy.
Ps. If you MAKE it and LIKE it, please POST a make. Thanks.