Tape Cutter with Hacksaw blade
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.82 – €1.00 net (excluding VAT)
For file: 083P. Tape cutter_0.2mm_PLA_MINI_1h1m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.91 excluding VAT (range midpoint).
- Weight reported by the author
- 9 g
- Print time reported by the author
- 1.02 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Packing / masking / duct tape (2") cutter sleeve. Works better than standard PLA only versions. Req hacksaw blade
- Rating
- 4.5 / 5
- Likes
- 61
- Downloads
- 178
- Makes
- 2
- Views
- 1,755
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Tape cutting sleeve for 50mm (2") wide tape rolls.
Read reviews of PLA only versions that didn't do a good job a cutting the tape, so designed one with a serrated blade.
Material : PLA
Layer height : 0.20mm
Supports : No *
*Printed mine with supports for the small round holes, then had trouble cleaning them out.
Requirements
- Old or new hacksaw blade.
- Tin snips
- Drill with ~5mm bit for steel
- Sml zip tie.
Steps.
- Print model in PLA.
- Trim a new or old (I used old) serrated hacksaw blade to 50mm using tinsnips.
Nb. a cutter blade could be used but the interest of safety I used a serrated blade. - Insert blade into a print so he blade buts up against the end & side of the channel.
- Use a permanent marker to mark the hole positions on the blade.
- Remove the blade and score the drill points with a punch.
- With a high speed steel bit (~5mm) drill 2 holes where in the marked positions.
(I used an old piece of timber and secured the blade with nails) - Re-insert the blade into the cutter sleeve and check the hole alignment.
- Secure with a sml zip tie, ensuring the buckle is on the outside.
Enjoy.
Ps. If you MAKE it and LIKE it, please POST a make. Thanks.