1 / 5
Remix of Knurling Control Knob Cap for Ender 3 - for Larger Hands + Tighter Fit — zdjęcie 1
1 / 5

Remix of Knurling Control Knob Cap for Ender 3 - for Larger Hands + Tighter Fit

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a slightly larger version of rtm's knurled knob cap or cover for the stock control knob on Ender 3s, 5s, etc.

Ocena
4 / 5
Polubienia
4
Pobrania
53
Wydruki
2
Wyświetlenia
498
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This knob cap fits over the stock control knob on Ender 3D printers, and has a finger hole or indentation to allow the user to jog or spin the wheel with one finger. It has a knurled side surface for grip when making fine adjustments of the controls. This is a remix which provides a slightly larger knob and finger hole than rtm's original design:

https://www.printables.com/model/16928-knurling-controll-knob-knob-cap-for-ender-3

I printed rtm's knob cap and liked the design, but wanted to make a few refinements and/or adjustments for my finger size. As follows:

  • I reduced the inside diameter by about 0.34mm to provide a tighter fit.
  • I increased the overall diameter of the knob by 2mm, to allow for a larger finger hole that is farther out from the center.
  • I increased the size and depth of the finger hole to accommodate my large fingers; this required that the remixed knob's face surface is a little thicker.
  • I decreased how far down the sides of the remixed cap go down so that they do not protrude down below the bottom lip of the original knob.

NOTE:     The model prints upside down with the face of the knob cap touching the print bed. No supports are needed. I printed with PETG at 100% infill and with 0.16mm layer height. This design has tight tolerances for its fit over the original knob; some internal cleanup of printer artifacts may be required.

Tagi