Wall-Mountable Soap Dish (for Tesa PowerStrip S)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall-mountable Soap Dish that requires no holes
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 208
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Share Alike
We have a very small Guest bathroom with no proper place to put the soap. So I designed this soap dish. It mounts to any flat wall using two Tesa PowerStrip Small Double-sided adhesion strips. Since the strips are slightly longer than the dish they will hang over at the bottom, which is ok and allows for easier removal.
The inside bottom has a constant tilt to allow for Water to reach the hole at the bottom right.
If you need the hole at the other end, simply mirror the model in your slicer.
I did not yet print this model myself because my SO simply bought a soap dish without informing me >.<
It is however designed to be supportless.
If you printed this, please make a picture, then I can add it to this make. Thanks in advance! :-)
FreeCAD source files included as always!