Super 73 Loominade Honeycomb Headlight grill
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here is design for the Super73 RX Loominade headlight. It should fit the Kanebilt too (I think it's the same housing?)
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 151
- Wydruki
- 1
- Wyświetlenia
- 1282
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Ok so I just bought my Loominade headlight and installed it but thought it would be cool if it had a grill. I didn't like the grills online, so I decided to make my own based on the honeycomb pattern on my Union State rear rack. I printed it in PLA and used 15% infill at 0.16 Layer Height using a raft and tree supports on my Ender3 V2 with a PEI sheet and CRtouch auto leveling. Print time was about 34hrs with my current settings. In the photos, I installed the Version 2 of the headlight grill, and I noticed the fitment was too tight. The holes for the bolts were too exact as well, so I made the overall model 5MM wider and Higher, then I enlarged the holes 1MM. Should be fine now but take it as a warning.