Insulated Spade Connector Holder Block
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small lightweight block to hold insulated spade terminals together under tension
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 396
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Designed for use with a segmented EFHW amateur radio antenna.
The block holds red 22-14awg insulated spade connectors and will not let them separate under lateral tension while strung up. (As long as the terminals connected are smaller than 11x11mm in the center and the ends are less than 6mm wide, they should fit.)
A velcro strap is used to keep the blocks attached to the terminals. I designed the slot for these straps from Home Depot. The slot is 15mm x 2mm.
Print weight: approx. 4g
Print time (40% infill, 0.24 layer height): approx. 30 mins.