Rockshox Manual Front Suspension Lockout Switch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement lockout switch for a front suspension Rockshox fork. My fork is a coil fork, so I don't know if…
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 144
- Wydruki
- 2
- Wyświetlenia
- 786
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a replacement lockout switch for a front suspension Rockshox fork.
My fork is a coil fork, so I don't know if it works with their air forks.
It was attached with a sheet metal/wood coarse thread screw. An octagonal inset in the bottom mates to the fork, & is used to actuate the lockout itself.
My fork is a Rockshox Recon Silver, 100 mm travel, G2 geometry. I can't speak to compatibility on other forks. The crown geometry may not be the same, so the switch may not fit.
How I Designed This
Took dimensions off my own switch.
I guessed the countersink angle to be 90 degrees.
I optimized the switch to clear obstructions on the fork first & to get a good fit with the octagonal piece. I then increased the wall thickness until it would run into the crown of the fork, to bolster strength.
Updates
25 Jun 17: Octagon feature is too big. Want nominal 9.5 mm circumscribed circle for a looser fit, 9.4 mm for an ideal (tight fit). You'll have to press the switch on if you choose 9.4 mm. CAD will be 9.4 mm
Category: Replacement Parts