1 / 5
Prusa Enclosure Leg Braces - (2x #12 Screws) — zdjęcie 1
1 / 5

Prusa Enclosure Leg Braces - (2x #12 Screws)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Thanks to Jared596 for the original. These braces have helped out a lot on the shaky, cheap Lack table legs. (The…

Ocena
5 / 5
Polubienia
14
Pobrania
73
Wydruki
2
Wyświetlenia
1790
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Thanks to Jared596 for the original. These braces have helped out a lot on the shaky, cheap Lack table legs.

(The little logo isn't on this upload, it's just for personal use.)

This remix is based around the #12 3/4" screws recommended by Prusa for the rest of the v1 enclosure in their blog post. (The holes are 6mm in diameter). The braces use only 2 screws instead of 4 (I was low on resources).

Screw holes have a tear-drop shape for printability, there's a slight chamfer on the inside/outside of the main corner in just there's a bump, and a small triangle overhang adds bonus support to the other side of the brace.

--Cheers

Category: Replacement Parts

Tagi