1 / 6
Foldable Punisher Phone Stand — zdjęcie 1
1 / 6

Foldable Punisher Phone Stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A foldable phone stand that is fully printable. This prints fully assembled. Print Fold and use 203.7mm Length x 50mm…

Ocena
0 / 5
Polubienia
20
Pobrania
178
Wydruki
0
Wyświetlenia
782
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

A foldable phone stand that is fully printable.

This prints fully assembled.

  • Print
  • Fold and use

203.7mm Length x 50mm Width (LxW)

Update 4/15 Uploaded file without the new hinge supports. Now fixed.

Update: Added an improved model that has added supports, a friction latch to hold the stand closed when folded, and additional clearance below the phone cradle.

Print Settings

Printer:

HyperCube Evolution

Rafts:

No

Supports:

Yes

Resolution:

.2 mm

Infill:

20%

Filament:

3D Solutech PLA

Your choice


Notes:

Notes:
The hinge is designed to print reliably at first layer .3mm and a layer height of .2mm.

Other print resolutions will work, but check them in the slicer that clearances aren't affected.

Since this is printed flat it is a large print. (203.7mm Length x 50mm Width)

Updated stand directions

The updated stand should be printed with the slicer supports off.

After printing the designed-in supports need to be removed:

  1. At each hinge there are 5 small supports.
  2. Two phone cradle supports.
  3. Friction latch supports.

These supports are internal and hold the latch in place during printing.

(Below are the instructions from my Rose design on freeing the latch from the supports.)

Post-Printing

There are four internal supports for the latch. Two are positioned at the front of the latch near the cradle pass-through opening, and two at the rear.

  1. Fold the base to the center like shown above.
  2. Using a small object like a screwdriver gently press the latch down until the click of the front supports breaking away is heard.

To break away the rear supports press the latch in.

the latch should now be free to move.

Category: Mobile Phone

Tagi