Kossel Delta Plus Bed Clamp with Glass Clamps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed for the Kossel Delta Plus with 240mm heated bed. The clamp holds a 3mm thick heated bed and optionally a 3mm…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 445
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Designed for the Kossel Delta Plus with 240mm heated bed.
The clamp holds a 3mm thick heated bed and optionally a 3mm glass build plate.
I have been using this on my delta for the last three weeks and I'm very satisfied with this design.
Material:
- Bed Clamp - Uses the screws and nuts from the original clamps
- Glass Clamp - Three M4 x 10mm screws and hex nuts
If you're wondering what the red fan is in the photo, it's a Bed Cooling Fan to speed up the cool down of the glass bed.
I installed it on the delta and wired the 12V fan directly to the Heater1 connection on the Trigorilla board. I did not use an external MOSFET as described in the Bed Cooling Fan install. The MOSFET on the Trigorilla board is quite capable of handling the load of a standard 12V cooling fan.
To control the fan I entered in the slicer's end gcode:
M42 P45 S255 ;(Pin 45) ;Bed Fan ON
M190 R30 ;Set Bed Temp to 30c and wait
M42 P45 S0 ;(Pin 45) ;Bed Fan OFF
M140 S0 ;Bed Heater Off
Print Settings
Printer:
Anycubic Kossel Delta Plus
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
40% or greater
Filament:
Hatchbox ABS
Black
Notes:
Designed for .2 mm layer height.
Print as oriented in the stl's.
An X-Acto knife or drill can be used to remove the support material in the Glass Clip screw hole.
Category: 3D Printer Parts