Kossel Delta Plus Bed Clamp with Glass Clamps
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed for the Kossel Delta Plus with 240mm heated bed. The clamp holds a 3mm thick heated bed and optionally a 3mm…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 47
- Makes
- 0
- Views
- 445
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Designed for the Kossel Delta Plus with 240mm heated bed.
The clamp holds a 3mm thick heated bed and optionally a 3mm glass build plate.
I have been using this on my delta for the last three weeks and I'm very satisfied with this design.
Material:
- Bed Clamp - Uses the screws and nuts from the original clamps
- Glass Clamp - Three M4 x 10mm screws and hex nuts
If you're wondering what the red fan is in the photo, it's a Bed Cooling Fan to speed up the cool down of the glass bed.
I installed it on the delta and wired the 12V fan directly to the Heater1 connection on the Trigorilla board. I did not use an external MOSFET as described in the Bed Cooling Fan install. The MOSFET on the Trigorilla board is quite capable of handling the load of a standard 12V cooling fan.
To control the fan I entered in the slicer's end gcode:
M42 P45 S255 ;(Pin 45) ;Bed Fan ON
M190 R30 ;Set Bed Temp to 30c and wait
M42 P45 S0 ;(Pin 45) ;Bed Fan OFF
M140 S0 ;Bed Heater Off
Print Settings
Printer:
Anycubic Kossel Delta Plus
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
40% or greater
Filament:
Hatchbox ABS
Black
Notes:
Designed for .2 mm layer height.
Print as oriented in the stl's.
An X-Acto knife or drill can be used to remove the support material in the Glass Clip screw hole.
Category: 3D Printer Parts