16mm or 19mm tent pole to 22mm PVC holder for scrog net
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For 16mm or 19mm grow tent poles. Used for scrog or to reduce negative pressure wall deformation. (updated 8/29/2022)
- Ocena
- 5 / 5
- Polubienia
- 85
- Pobrania
- 683
- Wydruki
- 3
- Wyświetlenia
- 3678
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
Best printed with PETG for it's flexibility. PLA works too but may be more difficult to snap on the tent pole. I've had luck with infill anywhere between 10-30%. This was designed to print easily with no supports needed.
Updated 9/12/2022: 19mm version tested and reported as good.
Updated 9/1/2022: Added 19mm tent pole version by request. I have not tested it as I do not own a tent with a 19mm pole, so please let me know if there are issues. Thanks.
Updated 8/29/2022: Sorry I didn't notice the non-manifold geometry. That has been fixed and all internal geometry is also removed.
These brackets are designed for 16mm grow tent poles and ½ inch diameter PVC. Typical uses are for scrog nets and/or added tent wall structure.
Updated 5/17/2025:
I get request for different sizes, so now you can make your own adjustments.
Scog_bracket.FCStd is a FreeCad file you can use to customize your bracket.
Please see scrog_example1 to see which sketches you can use to modify the vertical cylinder part.