1 / 2
Center Spot finder — zdjęcie 1
1 / 2

Center Spot finder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Makes centering the mirror easier for collimation process, using reinforcement labels.

Ocena
5 / 5
Polubienia
104
Pobrania
1105
Wydruki
25
Wyświetlenia
4083
Oceny
21

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

If you're like me and not got steady hands, this will make centering the mirror without the use of guides which require steady hands a breeze. And all it takes is about a minute.

The inner printed side facing the mirror (no need for outer circumference) needs sellotape pressed (stops scratching mirror surface) and trimmed with a very sharp implement like a scalpel, these can be purchased cheap. The outer perimeter will fit snug around the glass, so if there's a beveled edge, it will still find center.

Reinforcement labels I used were Avery 6755.

PLA+ was used with a .3 nozzle , layer height of .16. Takes about 30 minutes at 40mm/s

.4 nozzle might work but have not printed 

Tagi