1 / 1
85mm Bottle Holder for 3x3 5/8" Power Rack
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bottle holder for 3x3" power racks with 5/8" pins.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 149
- Wydruki
- 0
- Wyświetlenia
- 1014
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (1)Kolekcje (18)Powiązane
Bottle holder for 3x3" power racks with 5/8" pins. Designed to hold an 85mm 1L CamelBak insulated Eddy+.
Must be printed with some kind of support for the pin. I used the Tree support in Cura, but others should work as long as the pin is supported.
Printed in PLA at 20% infill. Works okay but the parts that wrap around the post might be a bit thin at .125" - it works, but it flexes a little with a full water bottle. You might want to consider bumping it up to .2-.25" and printing with a higher infill.