Curvy 6 Pack Carrier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This carrier holds 6 12oz cans.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 179
- Wydruki
- 2
- Wyświetlenia
- 1676
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This carrier holds 6 12oz cans. The handle and anchors are screwed together using 2 M5 screws (8mm or 16mm, either one will work). Two pairs of 6x3mm magnets hold the top and bottom half together. It is a tight tolerance (0.5mm) between the can and the walls to prevent them from rattling around in the carrier.
Edit (3/20): Just noticed today that the top was missing one of the insert holes for the 6x3mm magnet... My bad...
Print instructions
I used the default Prusament PETG settings since I printed it using generic Amazon PETG. The only change I made was I used 4 perimeters. I recommend doing this as well as the walls are deigned to be exactly 1.6mm wide.
The only part that needs support is the handle due to the fillets on it. Be sure to orient all the prints so that there aren't any overhangs to save on support filament.