Curvy 6 Pack Carrier
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.79 – €0.96 net (excluding VAT)
For file: handle-anchor_02mm_petg_mk3s_1h0m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.88 excluding VAT (range midpoint).
- Weight reported by the author
- 9 g
- Print time reported by the author
- 1 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This carrier holds 6 12oz cans.
- Rating
- 5 / 5
- Likes
- 19
- Downloads
- 179
- Makes
- 2
- Views
- 1,676
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
This carrier holds 6 12oz cans. The handle and anchors are screwed together using 2 M5 screws (8mm or 16mm, either one will work). Two pairs of 6x3mm magnets hold the top and bottom half together. It is a tight tolerance (0.5mm) between the can and the walls to prevent them from rattling around in the carrier.
Edit (3/20): Just noticed today that the top was missing one of the insert holes for the 6x3mm magnet... My bad...
Print instructions
I used the default Prusament PETG settings since I printed it using generic Amazon PETG. The only change I made was I used 4 perimeters. I recommend doing this as well as the walls are deigned to be exactly 1.6mm wide.
The only part that needs support is the handle due to the fillets on it. Be sure to orient all the prints so that there aren't any overhangs to save on support filament.