Elegoo Mars Lid Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple model to hold the lid of the original Elegoo Mars resin printer so it doesn't eat up desk space
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 846
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple model to hold the lid of the original Elegoo Mars 3D Printer.
You will need 2 m4x16 screws as the original screws are not long enough with this piece installed.
To install take the two m4 screws holding the top plate of the x-axis rail off, put the printed part over it and re-install it with the new screws. I recommend flipping the plate over and using washers just to give the screws a slight amount of extra support from the mounting pressure. I'm not sure it actually makes any difference but it at the very least doesn't hurt anything.