Elegoo Mars Lid Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple model to hold the lid of the original Elegoo Mars resin printer so it doesn't eat up desk space
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 72
- Makes
- 0
- Views
- 846
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
This is a simple model to hold the lid of the original Elegoo Mars 3D Printer.
You will need 2 m4x16 screws as the original screws are not long enough with this piece installed.
To install take the two m4 screws holding the top plate of the x-axis rail off, put the printed part over it and re-install it with the new screws. I recommend flipping the plate over and using washers just to give the screws a slight amount of extra support from the mounting pressure. I'm not sure it actually makes any difference but it at the very least doesn't hurt anything.