SilverCrest soap dispenser SSE 4,5 B2 extended base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
So my soap dispenser's battery compartment totally coroded and it was far too gone to be fixed. Made a new one instead.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 288
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
Well this isn't really a direct replacement, I put in a 6x AA battery holder and a small DC/DC step-down converter set to 4,5V.
For printing you need to support only the small 2 clips and after printing you have to use a dremel or a similar tool to cut away the excess material from bottom side of the clip. Trial and error I guess :)
There are also 2 sacrificial layers - for easier printing of 2 screw holes - 2 on bottom and 2 on top side of both holes. Just use a small drill or a dremel to cut it away.
I printed it from PETG, standard Prusament setting, 20% infill and 0,3mm layer height.