SilverCrest soap dispenser SSE 4,5 B2 extended base
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
So my soap dispenser's battery compartment totally coroded and it was far too gone to be fixed. Made a new one instead.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 13
- Makes
- 0
- Views
- 289
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial
Well this isn't really a direct replacement, I put in a 6x AA battery holder and a small DC/DC step-down converter set to 4,5V.
For printing you need to support only the small 2 clips and after printing you have to use a dremel or a similar tool to cut away the excess material from bottom side of the clip. Trial and error I guess :)
There are also 2 sacrificial layers - for easier printing of 2 screw holes - 2 on bottom and 2 on top side of both holes. Just use a small drill or a dremel to cut it away.
I printed it from PETG, standard Prusament setting, 20% infill and 0,3mm layer height.