micro:bit croc clip keeper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Works with a micro:bit v1 or v2. Note that the edge comes very close to some small components 10 mm from the edge of…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Works with a micro:bit v1 or v2. Note that the edge comesvery close to some small components 10 mm from the edge of the board, but shouldn't touch or interfere unless your printer's Z-scale is incorrect. As ever, take care fitting anything to a circuit board …
tiny guard piece to stop croc clips / alligator clips shorting out on your micro:bit. Designed entirely from the Kitronik mechanical drawings, as the official ones are useless.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
15%
Filament: Filaments.ca Canadian Maker Series Low Sheen Tough PLA Black
Notes:
No supports, but you might want to enable bridging.
Model already has elephant's foot compensation built in.Category: Electronics