Exercise Bike Timer Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Our very basic exercise bike has no timer, so this is a simple clamp to hold a kitchen timer. The clamp is secured…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 194
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Our very basic exercise bike has no timer, so this is a simple clamp to hold a kitchen timer. The clamp is secured with a VELCRO® brand One-Wrap® thin cable tie.
As designed, the clamp fits around a ~36 mm diameter foam-covered bar. The timer used has a chunky clamp which means the holder needs a lot of clearance to fit through. Consequently, it's a bit loose but won't fall out.
VELCRO® and One-Wrap® are registered trademarks of Velcro BVBA.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2 mm
Infill:
20 %
Filament: eSun PLA+ n/a
Notes:
You probably don't need a raft, but you might want a brim to help with adhesion.
You*definitely* need supports with this design, but check in your slicer before printing to ensure that there's no support in the channel for the cable tie. Any support here will be**really** hard to remove. For me, using Cura, I found that increasing the*Support X/Y Distance* slightly (from 0.7 to 1.0 mm) made the problem go away.See the bar clamp support image for details.
Category: Sport & Outdoors