Functional Followspot Lamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small model of Robert Juliat's Cricket followspot that can be used as a lamp.
- Ocena
- 0 / 5
- Polubienia
- 87
- Pobrania
- 104
- Wydruki
- 0
- Wyświetlenia
- 2265
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial
PLEASE DROP A LIKE IF YOU LIKE MY MODEL, IT MEANS A LOT!
Introduction
Preview model was made in Fusion 360 and tested on Prusa MINI+ with Prusament galaxy black PLA and galaxy silver PLA (except LED holder, which was made with Pursament PETG to stand higher temperatures, but i don't think that's necessary).
Around 300 g of filament used and estimated 50 hours of printing (in 0.15mm quality).
Why did i choose to make this model? I felt like it would be cool to have it at home. Currently it serves as a desk lamp.
Non-printable parts needed for assembling:
Electronics:
MR16 EV7W LED (or any other source with GU5.3 socket)
12V 1A transformer (usually sold for LED lights)
Not important, but looks cool:
30mm fan (Raspberry Pi 5V fan for example)
40 ohm resistor (can be higher, used to transfer 12V to 5V for the fan)
Others:
Bolt 8 x M4x10 or similar
Nut 4 x M4
Bolt 3 x M3x15 (important for iris)
Bolt 2 x M3x20
Nut 3 x M3
5 colored filters + 1 frost filter
Strong glue
That's all!
All the instructions are in the photos. This is my first thing i ever created and printed, so i apologize for any mistakes i made. If you have any question, please leave a comment.
Looking foward for your makes! Enjoy!