CR-10(S) Caribou (Zaribo/Prusa/BMG) MOD
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
https://caribou3d.com/en/ provides pretty printer kits based on Prusa, so which changes are needed to mod a cr-10s, or…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 71
- Wydruki
- 0
- Wyświetlenia
- 856
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
https://caribou3d.com/en/ provides pretty printer kits based on Prusa, so which changes are needed to mod a cr-10s, or similar, this way step by step?
PINDA depends to the printbed so I think a PINDA BLTouch replacement shlould be nice. Also the Sensorless homing should be replaced by the limit switches for now. Sensorless homing could be implemented later on, also GT3 Belts and so on.
This mod should work with all 20x40 frames sized like Creality CR-10
So this is something like a 1st service and I call it Crealibou
BTW, meanwhile using 10mm rods for Z was not the best idea. This solution is not bad but using MGN12 Rails meight be better
Edit: converted the modelfile from f3d to step
Category: 3D Printers