1 / 3
Rod holder / Bungee cord attachment for roof of Vw Golf Variant Mk VI — zdjęcie 1
1 / 3

Rod holder / Bungee cord attachment for roof of Vw Golf Variant Mk VI

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Needed a attachment for some bungee cords so I could transport my fishing rods.

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
422
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

Tried goggling what the attachment points are called in the roof of the car without luck. So I do not know if they fit other models of VW. Behind the slidy thingy the main hole is 20mm and the groove is 10mm.

Printed with normal settings at 0.2 layer height with supports. I used ASA filament with 20% Gyroid infill.

to fasten it in place you need M10x30 bolt (I used stainless). I cut a slot to the end of the threaded part with a 1mm death wheel disc (picture), you can use manual steel saw, dremel or anything you have that can make a slot in the bolt. With this slot I can use a flathead to tighten the attachment to the car. The bolt needs to be roughly half way down the hole and put it in almost upside down and then rotate it into place and then tighten.

The bungee cord I used is a Quickloader Butterfly with adjustable length but you can use any that has at least a 24mm (inner) hook.

Tagi