Retevis RB17V belt clip mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple flat surface mount for belt clip mount radio RB17V. May likely work for other belt clips; see measurements.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 56
- Wydruki
- 1
- Wyświetlenia
- 430
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple surface mount attachment point for a belt clip radio. Measurements were taken and generalized for a cheap RB17V Retevis MURS radio.
The gap accommodates a clip 25mm wide. The mounting surface is 4mm thick (check gap between clip and radio). The maximum clearance is 8.5mm (see the thickest part of your belt clip, generally the tip near the bottom). Mounting holes are 5mm to accommodate a variety of screws or bolts.
Prints in under 40min with a 0.3mm Z and 20% infill. 4walls on all surfaces is strong enough for my purposes, but your mileage may vary.