Retevis RB17V belt clip mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple flat surface mount for belt clip mount radio RB17V. May likely work for other belt clips; see measurements.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 56
- Makes
- 1
- Views
- 430
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple surface mount attachment point for a belt clip radio. Measurements were taken and generalized for a cheap RB17V Retevis MURS radio.
The gap accommodates a clip 25mm wide. The mounting surface is 4mm thick (check gap between clip and radio). The maximum clearance is 8.5mm (see the thickest part of your belt clip, generally the tip near the bottom). Mounting holes are 5mm to accommodate a variety of screws or bolts.
Prints in under 40min with a 0.3mm Z and 20% infill. 4walls on all surfaces is strong enough for my purposes, but your mileage may vary.