Pi 5 inch DSI display case with magnet mount

Case for Pi3B+ with 5inch DSI display. May work with other Pi models, but I don't have the equipment to try it out.

Hardware required:

1. 6x 8x5mm magnets. You could get away with 4 magnets too.
2. 4x M2.5x10mm screws, or use the 2 provided with the display for screen stand.
3. 8x M3x6mm Philips Screw or similar.
4. 2x M4x10mm screws with nuts, preferably nyloc or use loctite
5. CA glue/Superglue
6. 30mm 5v fan

Be aware that this model would prevent the use of ethernet port, as there is a mounting for the display there.

Assembly instructions:

1. Print each model. No supports are required. Ensure that you can do at least 40mm bridges.
2. For L&R bracket, add a pause print to layer 18 if using 0.2mm layer height. If using other layer heights, please refer to the image. You need to pause it before it covers the hole. 
3. Put the display with attached Pi and cable connected to the LCD_Front.
4. Screw the LCD_Rear to LCD_Front using m3x6mm screws.
5. Put in 2x M4 nuts in the inner side of LCD_Rear. Using CA glue will hold it in place during assembly.
6. Install the Pi_Cover. Fix it with M2.5 screws. 
7. Apply some superglue to the LCD_Rear arm to the Pi_Cover, and add some to the sides. Just a little amount is enough
8. Assemble the L&R bracket with M4x10mm screws and you're done.

Attached are the DSI display I used for this case, yours might be different. If you have a different model or suggestion for better features, please let me know. I'd be happy to implement it. 

The reason that I designed the rear lcd and pi case as separate and not as one piece is due to the complexity during printing. If the case rear is a one piece part, you'd have to print with supports and the overall assembly would be bulky. Hence I decided to glue them together as the tolerance is pretty tight.

All parts are printed at 0.2mm layer height, around 5 hours in total on my FLSUN SR.