Replace Dog Collar Housing for Extreme Pro Dog Fence System
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a new housing to hold the electronics of a electric dog collar made for the Extreme Pro Dog Fence System.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 180
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Public Domain
You'll need a couple threaded inserts that match the shock prongs. You can reuse the original plastic slip piece that mounts the housing to the collar, you'll just need to open the holes a little bit (I used a dremel but a drill bit or sharp knife could do it). You could also use some threaded inserts to connect the lid to the bottom or just use a correctly sized screw.
There is a channel for a rubber belt to be pressed into which should help keep water out. A bead of silicone would work just as well.
I printed in ABS and then bathed the parts on acetone to smooth and also add water protection.