Mini Hygrometer Thermometer Angled Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are to hold your digital hygrometer/thermometer at an angle so you can read it. Three angles are available.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 48
- Wydruki
- 2
- Wyświetlenia
- 311
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I tried to print this stand from alarmba but it did not fit the cheap Chinese mini hygrometer thermometers I picked up on Amazon (USA), but the hole was too small. So I created these.
The hole in these stands is 25.5mm x 45 mm.
The angles are vertical, 22.5 degree backwards lean, and 45 degree backwards lean. The fit is snug and the parts are of minimal thickness so be careful when fitting it in. The walls are only 1 mm tick which is enough for this purpose and uses minimal material.
I printed the 45 degree one in PLA without issue. I haven't printed the other two.