Sharpie Bracers

Sharpie Bracers

For the Medieval Sharpie User. Show your co-workers you mean business.

I had a funky Celtic texture applied in Ideamaker but then both my FDM's went down and are awaiting parts. So I had to print them in resin. I couldn't get the texture to work and didn't have the time to figure it out.

---------------------------------------
Update:
My resin print failed and Amazon magically changed my replacement FDM extruder into pink beach towels. Woohoo!
Not sure if these will still be eligible for the contest, but oh well, here they are.
---------------------------------------

If you print them FDM, try the Ideamaker texture, because they looked soooo cool. When I get one of my FDM's back up, I will post pics of them with the texture.

There is a right and a left handed version. Print 2 of the “Both Wrist” parts each for either hand. Sharpie cap locks into the angled cylinder for rapid deployment.

You need a couple of pieces of elastic. Thread them through and knot the ends. Or you could use a couple of leather thongs, or twine etc and tie them on. (Maybe gold chain with clasps?)

Try:
PLA Pro
.2 Layer height
Supports required

If you like, like.

Conquer, permanently mark, and enjoy!